Ameba-Pro KVS Getting Started Guide
Getting Started Guide All information provided in this document is subject to legal disclaimers. © REALTEK 2020. All rights reserved.
15
Fig 5-2 Hardware setup
5.2.2
Software Setup
Execute ImageTool.exe from location project\tools\AmebaPro\Image_Tool\ImageTool.exe
5.3
Download
5.3.1
Enter the Download Mode to Ready
Image tool use UART to transmit image to AmebaPro board. Before performing image download function, AmebaPro need to enter
UART_DOWNLOAD mode first. Please follow below steps to get AmebaPro into UART_DOWNLOAD mode:
step 1.
Connect LOGUART with FT pin by jumper cap.
step 2.
Connect USB->UART to PC by using micro-USB wire.
step 3.
Switch
“
1
”
to ON from SW7(2V0
、
2V1) or Switch
“
2
”
to ON from SW7(1V0)
step 4.
Push reset button.
