Robert H Peterson Co. Model: VR-2A
9-9-20 Page 6
TRANSMITTER WALL CLIP
The transmitter can be hung on a wall using the clip provided. If the clip is
installed on a solid wood wall, drill 1/8" pilot holes and install with the screws
SURYLGHG,ILWLVLQVWDOOHGRQDSODVWHUZDOOERDUGZDOO¿UVWGULOOWZRKROHVLQWR
WKHZDOO7KHQXVHDKDPPHUWRWDSLQWKHWZRSODVWLFZDOODQFKRUVÀXVKZLWK
the wall; then install the screws provided.
WALL CLIP
SLOT
WALL CLIP
BATTERY
COMPARTMENT
BATTERY LIFE
Life expectancy of the alkaline batteries in the remote can be up to 12 months
depending on use of the servo function. Replace all batteries annually. When
the transmitter no longer operates the remote receiver from a distance it did
previously (i.e., the transmitter's range has decreased) or the remote receiver
does not function at all, the batteries should be checked. It is important that the
remote receiver batteries are fully charged, providing combined output voltage
of at least 4.5volts. The transmitter should operate with as little as 2.5 volts
battery power. NOTE: Extensive use of the SERVO MOTOR setting will reduce
WKHUHFHLYHUVEDWWHU\OLIHVLJQL¿FDQWO\
TROUBLE SHOOTING
,I\RXHQFRXQWHUSUREOHPVZLWK\RXU¿UHSODFHV\VWHPWKHSUREOHPPD\EHZLWKWKH¿UHSODFHLWVHOIRULWFRXOGEHZLWKWKH
UHPRWHV\VWHP5HYLHZWKH¿UHSODFHPDQXIDFWXUHUVRSHUDWLRQPDQXDOWRPDNHVXUHDOOFRQQHFWLRQVDUHSURSHUO\PDGH
Then check the operation of the remote in the following manner:
1. Make sure the batteries are correctly installed in the RECEIVER. One reversed battery will keep receiver from
operating properly.
2. Check battery in TRANSMITTER to ensure contacts are touching (+) and (-) ends of battery. Bend metal contacts in
IRUWLJKWHU¿W
3. Be sure RECEIVER and TRANSMITTER is within 20 to 25-foot operating range.
4. Keep RECEIVER from temperatures exceeding 120° F. Battery life shortened when ambient temperatures are above
115° F.
5. If RECEIVER is installed in tightly enclosed metal surround, the operating distance will be shortened.
6. Clear Codes: Memory in the receiver might be full if the learn button is pressed too many times. If this happens it will
not allow any more codes to be learned and no audible beep will be heard. To clear memory, place the receiver slide
switch into the REMOTE position. Press the learn button and release after 10 seconds. You should hear three (3)
long audible beeps indicating all codes have cleared. You can now “learn” the transmitter to the receiver as described
in the General Information Section.
f i r e - p a r t s . c o m
