Reaim 2 in 1 Machine, Instruction Manual, Page: 15 / 35

15
2.3 Emptying the tank
2.3.1 Place vacuum squarely on a stable
surface, such as ground, floor, bench,
etc.
2.3.2 Remove the power head assembly
of the wet/dry vacuum by pulling
outward on the latches located on each
side of the vacuum. Lift off the motor
housing assembly.
2.3.3 Dump the tank connects into the
proper waste disposal container.
WARNING: To reduce the risk of injury
from accidental starting, unplug power
cord before emptying the tank.
3.1 Filter
Your filter should be cleaned often to
maintain peak vacuum performance.
NOTE: The filter is made of high quality
material designed to stop small particles
such as sawdust. Handle the filter
carefully when removing to clean or
installing a new filter. Do not tear the
filter during removal or installation if
your intent is to reuse the filter.
3.2 Easy to replace Filter
1. Extend the retainer band around the
plastic posts on the lid.
2.
Remove filter bag off the filter cage.
3. Place the replacement filter on the
filter cage until open end touches
bottom of lid.
4. Release the retainer band from the
plastic post on the lid, holding the filter
bag secure to the lid.
5. Make sure the retainer band is
positioned on the filter bag.
IMPORTANT: To avoid damage to the fan
and motor, always reinstall the filter
before using the vacuum for dry material
pick-up.
Take the dirty filter to a disposal
container and gently brush away small
dirt particles that may be adhering to
the filter material.
IMPORTANT: After cleaning, check the
filter for tears or small holes. Do not use
a filter with holes or tears in it. Even a
small hole can allow a lot of dust to
come out of your vacuum. Replace it
immediately.
3.3 Installation
Before installing the filter on the
vacuum, clean the area of the lid so that
the retainer band will seal the bag
against the lid and stop small particles
from bypassing the filter bag.
If the filter is not clean or damaged,
replace it on the filter cage. If it can’t
be reused, place a new filter over the
filter cage.
Replace the retainer band around the
filter. Make sure the retainer band is
positioned on the filter, and the filter
completely covers the filter cage. Also
make sure the edges of the filter are
EN
3. General Maintenance