- Power adapter
- Factory Settings
Power Adapter
1. Connect the Network and Power
Connect the DC plug on the power adapter to the DC port on the device and connect the other
■
end of the power adapter into an electrical power outlet.
Connect the ethernet cable between the Internet port on the device and the network port on a
■
router or switch to access LAN.
IP Address
1. Find out your ReadyNet QX300 IP Address
For ReadyNet QX300 lift the handset and enter ****, choose "1" and then choose "2", the IP
■
address will be recited.
Factory Settings
1. Reset to factory settings
This step is not required for out-of-the-box devices, however, if the device has been already used
then it is a must.
For ReadyNet QX300 press the reset button at the front of your router device for 10 seconds,
■
this will wipe out any changes made to your router.
Device will be reset to the factory default settings.
Wait sometime prior for device to reboot.
■
NOTE:
Do not unplug or remove power to the device while it is updating firmware and
configurations.
Registering Device
This chapter describes how to identify ReadyNet QX300 device model, requirements that must
be met and how to register the device using manual configuration or auto provisioning.
The following topics are covered:
- Manual Configuration
- Auto Provisioning
Manual Configuration
This chapter describes how to set UAD settings, create PBXware extension and register the
device.