RDM Pro 70007, Operating Instructions Manual

Page: 13 / 34

1) Insert charged battery in handle and secure
with release button. The spring must anap
into place.
2) Separate the bayyery from the machine
by pressing the realese button below the
machine handle.
b) Apply pressure only in direct line with the
bit and do not apply excessive pressure.
The bits can bend and cause breakage or
loss of control, resulting in personal injury.
1) Carefully insert the battery pack into the
base of the device. Pay attention to the
correct direction and do not insert the
battery pack upside down.
2) Insert the output plug of the device on the
left side of the base
3) Insert the power plug of the device into
the socket (up to 230V)
4) When the red indicator is lit, the battery
pack has been recharged. This process
lasts approximately 3-5 hours (for normal
load). Then the battery pack has been
fully recharged. Remove the charger
from the outlet. The battery pack can
then be removed from the base and used
immediately.
5) Do not charge the battery if the ambient
temperature is above 40ºC.
6) Never discharge the battery pack
completely and recharge from time to time
if it is not used for a prolonged period.
7) Always keep the surface of the charger
free of dust and dirt.
8) Storage of battery packs, which are
defective or damaged or that can no
longer be recharged, should be disposed
of as hazardous waste. Deliver them to
a special collection point. Never harm
our environment. Do not throw unusable
battery storage packs into household
trash, fire or water.
INITIAL OPERATING
CHARGE PROCESS
1
3
2
1. Cordless drill
2. Battery packet
3. Release button
1. Charger AC 230V
2. Cable of the charger to charger base
3. Plug (DC)
4. Indicator
5. Charger base
6. Battery packet
1
2
5
4
3
6