Engines
ATTENTION -ALL RCV ENGENES HAVE BEEN TEST RUN ON
PROSYNTH 2000 10% NITRO FUEL AND THE CAR BURETTOR NEEDLES HAVE BEEN SET AND DO NOT
NEED TO BE ADJUSTED
RCV130 -CD FOUR STROKE ENGINE OWNERS GUIDE
Thank-you for choosing an RCV Engine. With simple care this design can offer you years of trouble free service.
Some aspects of the RCV engine
are different to conventional engines therefore even if you are an experienced modeller please read all these instructions caref
ully before
using your engine. Please pay particular attention to the RCV CD do’s and don’ts listed below
before attempting to run your engine.
READ ALL INSTRUCTIONS BEFORE OPERATING YOUR RCV ENGINE!
WARNING! : -
Under no circumstances should the crankcase breather nipple be extended. If extended the oil resi-
due can cause crankcase compression which will restrict oil lubrication to the bottom end.
RC model airplanes & engines are not toys and are capable of causing serious injury to yourself and others if imprope rly used.
You should always: -
Keep hands and all foreign objects clear of the engine when it is operating.
Mount the engine securely on a bench mount or plane.
Use a good quality balanced propeller with no cracks or flaws, ensure this is tightened prior to each use.
Run your engine in an well ventilated area.
Not hand start the engine.
While the engine is running stand behind the engine to make adjustments and ensure proper safety clothing is always used
(eye goggles and gloves).
The safe operation of your engine is your responsibility so ensure that you operate your engine with care at all times
and ensure all spectators are kept at a safe distance.
SECTION 1
RCV 130CD DO's & DON'Ts
READ ALL THE INSTRUCTIONS BEFORE OPERATING YOUR
ENGINE
If in doubt, contact RCV Engines for advice.
ONLY USE RECOMMENDED FUELS
We recommend you use a methanol based fuel containing 10% Nitro.
For more information on fuels please see
SECTION 3
.
ONLY USE RECOMMENDED PLUGS
Fitting a non-recommended plug may produce a significant drop in per-
formance when the glow battery is disconnected.
SET UP THE CARBURETTOR CORRECTLY
As supplied, the idle needle is set at rich to protect the valve. To achieve
smooth running after running in, this must be adjusted as per instructions.
(SEE SECTION 6)
ENSURE THE EXHAUST IS PROPERLY TIGHTENED
Prior to use, tighten the exhaust pipe and muffler using the recommended
procedure
(SEE SECTION 4)
ENSURE ADEQUATE COOLING
4-stroke engines tend to run hotter than 2-strokes so provision for cooling
is important (
SEE SECTION 7
)
Issue 34
28/10/2008
130CD © RCV Engines Ltd
Page 1
This engine is subject to Global Patents and Design Copyrights inc. Int. Pat App. WO 03/062615
SECTION 2
RECEIVING YOUR ENGINE
We take every care to ensure this engine reaches you in perfect
condition. If this is not the case, please advise us at the earliest
opportunity. Your package should contain the following items:
Muffler
Carburettor
Glow plug
Allen Key for valve cover
Allen Key for carburettor manifold
Warranty Form (To qualify for the 2 year warranty & lifetime
repair guarantee, we must receive your completed
warranty form within 30 days of purchase.
RCV130-CD Engine complete with:-
Please Note:
1.
As part of quality control, engines are individually tested prior to
despatch. Your engine will be covered in a light coating of oil
used to protect it during transit.
2.
Please remove plastic plug from crankcase breather
3.
A photo user manual is also available for download from the
RCV website - www.rcvengines.com
GLOW PLUG
As the glow plug on the RCV is ported, selection is more critical
than on conventional engines, and fitting a non-recommended plug
may produce a significant drop in performance when the glow bat-
tery is disconnected. It is strongly recommended that the Pro plug
PP4T is fitted which has been specifically designed for the RCV
range.
DO NOT USE AN IDLE BAR PLUG. This may protrude into the
rotary valve, and lock the engine up, damaging the surface of the
rotary valve.
FUEL
For maximum efficiency, we recommend that 10% Nitro
content fuel is used. Fuel with too low a Nitro content will
produce a significant drop in RPM when the glow battery is
disconnected as well as a less reliable idle. Do not use fuel
with more than 15% Nitro as this could result in engine dam-
age.
Recommended Westonuk Liquid Gold Prosynth 2000 10% nitro
fuel.
Cheap fuels or home blended fuels may reduce the lifespan of
the engine. If
If Prosynth 2000 fuel is not available we recommend a fuel with a
high quality oil content with no castor.
PROPELLERS
The RCV130 -
There are numerous different sizes of propellers which could
be used and this is really dependent on the airframe and the type
of flying.
For general running in etc, RCV recommend an 15 x 8 APC type
Examples of suitable propellers are listed below.
We would recommend you try a number of different propeller sizes
and see which suits yourself and the application best.
Once your engine has been fully run in, you should expect the
following performance (this is a guideline only):
SECTION 3
GLOW PLUG, FUEL & PROP SELECTION
Propeller
Idle
RPM range
15 x 6
2200 - 2500
8000 - 9000
15 x 8
2200 - 2500
7500 - 8200
15 x 10
2200 - 2500
7000 - 7300
130-CD Exploded Parts View
Your engine is guaranteed free from manufacturing defects and
workmanship for a period of 24 months from date of supply*.
This warranty is limited to the original purchaser of the engine and is not
transferable.
This does not apply to damage caused by incorrect usage, handling,
running in, non-observance of these instructions, or modification.
Furthermore the manufacturers cannot be liable for any fault caused
through incorrect assembly or disassembly-assembly of the engine, our
factory offers a full after sales service should you require work done on
your engine.
*
To validate this guarantee we must receive your completed
warranty form and proof of purchase (send a copy of your receipt,
& keep the original) within 1 month of purchase.
This guarantee
does not affect your statutory rights.
Any engines being returned to RCV must have a returns number
(issued by RCV)
SECTION 9
GUARANTEE & TECHNICAL SUPPORT
Issue 4
28/10/2008
130CD © RCV Engines Ltd
Page 4
This engine is subject to Global Patents and Design Copyrights inc. Int. Pat App. WO 03/062615
For queries, warranty issues or more information on spares available,
please contact:
WESTON UK
84-88 London Rd, Teynham, Sittingbourne
Kent , ME9 9QH, UK
Tel:
+44 (0)1795 521030
Fax:
+44 (0)1795 522020
Web:
www.westonuk.co.uk
REMEMBER: SAFE OPERATION OF YOUR MODEL AND ENGINE IS
YOUR RESPONSIBILITY.
SPECIFICALLY, NO RESPONSIBILITY IS ASSUMED FOR ANY
DAMAGE TO ANY MODEL, ACCESSORY, RADIO CONTROL
EQUIPMENT, PERSON OR PROPERTY RESULTING FROM THE USE
OR MISUSE OF AN RCV MODEL ENGINE. IF IN DOUBT CONTACT
RCV ENGINES
RCV engines are inherently reliable, however as with all engines spares will sometimes be required. If you need to order any s
pares you can do so
either from your local hobby shop or from RCV direct. A list of available spares can be found on the RCV web shop. When ordering spares please
include the serial number of your engine. Some components below are only available as complete assemblies to enable RCV to keep
our spares at
the lowest possible prices. If you need different spares or would like help in identifying a spare please contact RCV.
