5. Position the unit to allow free air flow through the front grille.
EXHAUST
INTAKE
6. Wipe out inside of unit with a damp cloth,
7. Be sure to install the Anti-Tip bracket. Flow instructions provided with the Anti-Tip bracket.
!
The Anti-tip Bracket must be installed on
this unit before it is used. Double stacking
units may cause serious personal injury.
ANTI-TIP BRACKET INSTALLATION
To reduce the risk of tipping the unit by abnormal usage or improper loading, the appliance
must be secured by properly installing the anti-tip device packed with the appliance.
• Place the anti-tip bracket on the floor as shown in the figure. An anti-tip bracket can be
installed on either right or left side.
• Mark the locations of the 4 holes of the anti-tip bracket on the floor.
• Use a 5/16 masonry drill bit and insert plastic anchors.
• Secure bracket to floor using screws.
• Slide appliance into position and make sure the leg engages the anti-tip bracket.
NOTE:
If the unit is relocated, the bracket must be removed and installed in the new location.
826mm
Move the appliance to the final position.
Anti-tip Bracket
19.5mm
45.0mm
Anti-tip
Bracket
The contour line of front panel of appliance
The contour line of left panel of appliance
The contour line of right panel of appliance
The contour line of back panel of appliance
Install the anti-tip bracket either right or left side.
LEVELING THE UNIT
Position the unit on a flat, level surface capable of
supporting the entire weight of the unit when full.
This unit contains four (4) adjustable leveling
legs. Turn the legs clockwise to raise and
counterclockwise to lower.
Turn Feet
To Adjust
Screwdriver Screws
Door
Handle
INSTALLING HANDLE
Put the screws on the top of the drawer where
the handle is to be installed.
Align the handle with screws, tighten the
screws using the screwdrivers.
ELECTRICAL CONNECTION
WARNING
Improper use of the grounded plug can result in the risk of electrical shock. If the power
cord is damaged, have it replaced by a qualified electrician or an authorized service center.
!
This appliance should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug which mates with standard three-prong wall outlets to minimize
the possibility of electrical shock.
Do not under any circumstances cut or remove the third (ground) prong from the power cord
supplied. For personal safety, this appliance must be properly grounded. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.
This appliance requires a standard 115/120 Volt AC~60Hz three-prong grounded electrical
outlet. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet
is properly grounded. When a standard 2-prong wall outlet is encountered, it is your
responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet.
To prevent accidental injury, the cord should be secured behind the appliance and not left
exposed or dangling.
The appliance should always be plugged into its own individual electrical outlet which has a
voltage rating that matches the rating label on the appliance. This provides the best performance
and also prevents overloading house wiring circuits that could cause a fire hazard from over
heating. Never unplug the appliance by pulling on the power cord. Always grip the plug firmly and
pull straight out from the receptacle. Repair or replace immediately all power cords that have
become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage
along its length or at either end. When moving the appliance, be careful not to damage the
power cord.
EXTENSION CORD
Because of potential safety hazards under certain conditions, it is strongly recommended that
you do not use an extension cord with this appliance. However, if you must use an extension
cord it is absolutely necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance
extension cord having a grounding type plug and outlet and that the electrical rating of the cord
be 115 volts and at least 1.3 amperes.
6
7