1. Remove the components from the box and read
these instructions carefully in order to assemble
correctly.
2. Place the mortise cylinder (optional) 1-1/8" cylinder
length complete with straight or clover cam through
the 1-3/16" hole in the center of the aluminum face-
plate.
3. Mount the cylinder/switch bracket on the reverse
side of the faceplate (see below) making sure that
the teeth are positioned inside the grooves along the
cylinder, then attach the cylinder nut to fasten.
4. Insert the switch(es) into the 1/2" holes located on
the bracket below the cylinder. For ideal installation
thread the top nut an 1/8" down and tighten bottom
nut using a 9/16" wrench.
5. Make wire connections as required (see wire
connection figure below).
6. Fasten faceplate assembly to electrical box with the
tamperproof 6-32 machine screws supplied with the
spanner hand tool (also supplied).
4-3/4"
(120.6mm)
3" (76mm)
1-11/16" (N) (43mm)
1-1/2" (38mm)
27/32" (N)
(21.5mm)
CL
1/2" (13mm)
Switch Hole
(N) = Narrow Style 960N
1/4" (6.3mm)
2-3/4"
(70mm)
1-3/16"
(30mm)
Rear Profile
Optional (DPDT Switch)
Side Profile
Instructions
TAMPER-RESISTANT KEYSWITCH
960
I N S T A L L A T I O N
®
Red N/C
Black (Common)
Red N/O (Maintained)
Green N/O (Momentary)
(SPDT)
Wire Connection
©2011 RUTHERFORD CONTROLS INT’L CORP. WWW.RUTHERFORDCONTROLS.COM
USA: 2517 SQUADRON COURT, SUITE 104, VIRGINIA BEACH, VA 23453 • CANADA: 210 SHEARSON CRESCENT, CAMBRIDGE, ON N1T 1J6
PHONE • 1.800.265.6630 • 519.621.7651 • FAX: 1.800.482.9795 • 519.621.7939 • E-MAIL: [email protected]
IS960
PCN110045
R07/11SH