RCI 186M, Operator'S Manual, Page: 27 / 72

26
Service
Cam Bearing Replacement
Right end pickup cam bearing replacement.
1. Remove the cover from the cam track.
2. Remove the first tine bar guard from
the end for clearance to work.
3. Loosen the bolt retaining the cover tab
and move the tab for clearance to the
access hole for removal of the bearing
retaining bolt. See Figure 23.
4. Remove the cam bearing bolt.
5. Replace the cam bearing.
6. Reassemble components using red
loctite on the cam bearing bolt.
SPECIFICATION:
Cam bearing bolt torque: 46 lb-ft (63 N-m)*
*MUST USE RED LOCTITE
Straightening Bent Tines
There should be approximately 6” (150 mm)
gap between the point of tine disappearance
and the end of the slot.
If the distance is different, bend the tine
back to the original position of 6” (150 mm).
See Figure 24.
Figure 23. Access Hole Location
Key 1 - Access Hole Cover (1 each end)
Figure 24. Tine Gap
Key 1 - Tip of Tine
Key 2 - Gap of 6” (150 mm)