Motor
Mount the motor with the leads exiting over the top of the motor mount instead of through the bottom where the
cutout in the motor mount is. The Motor leads should be a good length to meet up with the ESC extension leads.
Tape or tie clip the leads in place.
Battery
To power this high spec wing we need a 2200mah 20C battery. The battery Is placed to the front of the bay and the
size of the bay is enlarged by cutting out some foam on either side.
Finishing Up
Secure all components with tie clips provided.
To secure the battery strap holder use a generous amount of Araldite to glue it in and press firmly against the foam
while it dries.
Leads go over the top to meet up with the ESC leads.
As this is a pusher setup we use a standard APC6040
prop. However, the prop is put on back to front and the
pos and neg connections are swapped.
