RCF TTL31-A, Owner'S Manual

Page: 42 / 56

42
For planes 1 and 2 Elevation refers to the elevation (height) of the front of the plane.
For plane 1 and 2 Distance relates to the actual distance from the front of the array to the start of the plane.
For all planes selecting Seated or Standing places ear level at 1.3 or 1.7m above the respective plane.
Filling the blank tabs it’s possible to start the program:
COVERAGE
Specify the horizontal coverage distances from the front of the array.
ARRAY INSTALLATION
Select either Suspended or Stack in the Array installation section to determines how the array is supported.
In Suspended mode the grid is suspended and cabinets are attached beneath.
In Stack mode the grid forms a base and cabinets are placed on top.
SUSPENDED MODE
AUTO H SETTING - MIN TRIM HEIGHT
This is the low limit for the array and is defined as the smallest allowable distance from the lowest point of the array to
the ground below
AUTO H SETTING - MAX SUSPENSION POINT
Set this to the maximum array height allowable (usually the highest part of the flying frame). The maximum pick height
is usually chosen to allow for the maximum flying point height minus a sensible allowance for any shackles, stingers,
bridles or flying hooks. 1m should be allowed for a stinger between each grid flying lug and the relevant motor hook to
ensure that motor chain bags do not rest on the grid or top cabinet and upset its tilt angle.
MANUAL H SETTING
In manual installation mode it is possible to enter the height required for flying the system.
NUMBER OF CABINETS AND MODEL SECTION
Array model and number of cabinets can be set depending also on cabs availability.