RCF nx series, User Manual

Page: 5 / 24

english
5
CONNECTIONS
The XLR connectors use the following AES standard:
PIN 1 = GROUND (SHIELD)
PIN 2 = HOT (+)
PIN 3 = COLD (-)
VOLTAGE SETUP
(RESERVED TO THE RCF SERVICE CENTRE)
BEFORE TURNING ON THE SPEAKER
At this point you can connect the power supply cable and the signal cable, but before turning on the speaker make sure that the volume
control is at the minimum level (even on the mixer output). It is important that the mixer is already ON before turning on the speaker. This
will avoid damage to the speakers and noisy “bumps” due to turning on parts on the audio chain. It is a good practice to always turn on
speakers at last and turn them off immediately after the show.
Now you can turn ON the speaker and adjust the volume control to a proper level.
WARNING: Always make sure that the maximum current requirement does not exceed the maximum admitted POWERCON
current. In case of doubt call the closest RCF SERVICE CENTRE.
HOT
SHIELD 2
3 1 COLD
SHIELD 1
COLD HOT
3 2
1
2
3
SHIELD
COLD
HOT
230 Volt, 50 Hz SETUP:
FUSE VALUE T5 AL 250V
115 Volt, 60 Hz SETUP:
FUSE VALUE T10 AL 250V