Step1：After the positive and negative terminal are correctly connected,
two eyelets wires will be penetrating out from both sides, and
the super capacitor should be placed in the shockproof pack.
Step2：The positive electrode of the super capacitor should be fastened to
the positive electrode of the battery.
Step3：Please make sure the capacitor is firmly fastened the connect the
resistor to the battery.
Step4：The clamp should be connected to the resistor before being
connected to the negative electrode of the battery.
Step5：When the red light of the correctly installed resistor is on, it
indicates the super capacitor is being charged. When the red light
is off, it indicates the charging of super capacitor is completed.
The temperature of resistor will become rather high during
charging. Do not touch it, or you may get burned.
Please check the terminals of capocitor and battery if the red light
on the resistor has been lit for a long time.
Step6：After the red light is off, the clamp and resistor can be removed. Be
carefully not to touch the aluminum case of resistor
because you may get burned due to the high temperature.
Step7：The negative electrode should be fastened to the battery to
complete the installation. The super capacitor should be surely
fastened to prevent it from being loosened during driving thus
causing short circuit.
Please handle super cap certainly to avoid short circuit.
Charge time：
SC-1572: 10-12 minutes.
SC-1520: 2-3 minutes.
