OPERATION OF TRANSMITTER
OPERATION OF HEADPHONE RECEIVERS
BATTERY INSTALLATION
The Green Auto ON/OFF indicator will be onwhen you plug the
adapter in the AC source and connect the audio plug to the audio
s o u rce. If the Auto On indicator is not lit (but the audio source is
ON) adjust the audio source output level which is greater than
the auto on indicator light in input level.
For protection of the transmitter and to save power, the
transmitter will be cut off automatically in the about one minute
when the input signal from audio source is too weak for
operation.
1) Set the Headphone Receiver’s VOL control to the
minimum position.
2) Turn the Receiver’s ON/OFF switch to ON.
3) Increase the Receiver’s VOL control setting slowly until you
hear the sound source which is connected to the transmitter.
Then, adjust the Receiver’s VOLcontrol for the desired lis-
tening level.
4) Adjust the size of the headphone by pulling down each end
(or pushing up to shorten).
1) Remove battery door by pushing in on the arrow at the
bottom of cover.
2) Insert one AAABattery for
each headphone earcup.
3) Replace the battery door
cover by sliding in the
opposite direction of the
arrow until it “snaps”.
When using the AAANi-Cd Rechargeable battery in your
headphones, you must charge for 24 Hours prior to first use.
Auto ON Indicator
CAUTION: Under normal working condition, the surface
of the transmitter will be slightly hot.
NOTE:
High levels from source may overload the
transmitter.
WHR100 Manual(1J1369) 6/10/99 1:43 PM Page 6
