Other Information
36
Chapter 4
The Remote Control Doesn’t Work
•
Something might be between the remote and the remote sensor on the component. Make sure there is a clear path.
•
Maybe the remote isn’t aimed directly at the TV/VCR.
•
Maybe batteries in remote are weak, dead or installed incorrectly. Put new batteries in the remote. (Note, if you remove the
batteries, you may have to reprogram the remote to operate other components.)
•
You might need to drain the remote’s microprocessor: remove batteries and press the number 1 button for at least 60 seconds.
Release the 1 button, replace the batteries, and (if necessary) program the remote again.
Problems with V-Chip
The rating limits don’t work
•
You must turn on the settings. Go to the
MENU
(press MENU on your remote), select
V-CHIP SET
, select
V-CHIP “ON”
.
I don’t remember my password
•
If you forget your password, simultaneously press VOLUME down on the TV/VCR front panel and the 0 number button on the
remote for a few seconds. This resets the password and you can enter a new one.
Care and Cleaning
CAUTION: Turn OFF your TV/VCR before cleaning.
You can clean the TV/VCR as required, using a soft lint-free cloth. Be sure to occasionally dust the ventilation slots in the
cabinet to help assure adequate ventilation.
The TV’s screen may be cleaned with a soft, lint-free cloth as well. Take care not to scratch or mar the screen. If
necessary, you may use a cloth dampened with warm water.
Never use strong cleaning agents, such as ammonia-
based cleaners, or abrasive powder. These types of cleaners will damage the TV.
While cleaning do not spray liquid directly on the screen, or allow liquid to run down the screen and inside the TV/VCR.
Also, avoid placing drinks or vases with water on top of the TV/VCR. This could increase the risk of fire or shock hazard or
damage to the TV/VCR.
Caution:
Using video games or any external accessory with fixed images for extended periods of time can cause them to
be permanently imprinted on the picture tube (or projection TV picture tubes). ALSO, some network/program logos, phone
numbers, etc. may cause similar damage. This damage is not covered by your warranty.
Front Panel
If you can’t find your remote control you can use the buttons on your TV/VCR to operate many of the TV/VCR’s features.
POWER
Turns the TV/VCR on or off.
RECORD Indicator
Lights when the One-Touch recording has been set.
T REC (Timer Record) Indicator
Lights when a timer program has been set and a tape with the safety tab is in the
TV/VCR. Also flashes when there has been a power interruption.
POWER Indicator
Lights when the TV/VCR is on.
HEADPHONE
Connect headphones (not supplied) to this jack.
VOL
Decreases the volume.
VOL ^
Increases the volume.
^
