EN
6
Operating the Clock
Turning off Alarm
Silence the alarm momentarily
Press
SNOOZE
. The alarm will sound again
when the snooze period is over. (see
“
Snooze Alarm Operation
”).
Stop the alarm
Press
OFF
. Then the alarm will be on the
following day at the same time.
Disable the alarm permanently
1. Press
CANCEL
button.
2. The
WAKE 1
and
WAKE 2
indicator will
be flashing.
3. Press
WAKE 1
or
WAKE 2
button within
3 seconds to deactivate the alarm function
permanently, “
OFF
” will be shown when
the above procedures are done.
Tip: You can activate the previously
set alarm time by pressing
WAKE 1
WAKE 1
WAKE 1
WAKE 1
WAKE 1
or
WAKE 2
WAKE 2
WAKE 2
WAKE 2
WAKE 2
button.
Snooze Alarm Operation
This operation allows extra sleep time af-
ter the alarm is on. The alarm will be off
by pressing
SNOOZE
until the snooze pe-
riod is over. Snooze function can be used
repeatedly up to 2 hours. After this, the
alarm will yurn off until the next alarm
conditions are met. Set the “quiet time”
as follow:
1. Press and hold
SNOOZE
.
2. Press
REV
or
FWD
to set the “quiet”
period (the default time is 9 minutes) from
1 minute to 30 minutes. Release button,
then the “quiet” period is set.
Seconds Time Display
The unit may display in seconds.
1. The clock should be in normal mode.
2. Press
or to show
seconds display.
3. Release to return to the hour and
minute display.
Brightness control
You can adjust the backlight by the
BRIGHTNESS
button, there are three
modes you may select from:
OFF
- Backlight always off.
HIGH
- Backlight always high.
LOW
- Backlight always low.
VOLUME
DISPLA
Y
Brightness
RP3710 EN
3/3/03, 4:30 PM
7
