LOCATION
•
Two people should be used when moving theappliance.
•
Remove interior and exterior packaging prior toinstallation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a lukewarm wet cloth.
•
Place the appliance on a fl oor that is strong enough to support it when it is fully loaded.
•
Do not place the appliance in direct sunlight or near sources of heat, such as a stove or heater,
as this can increase electrical consumption.near sources of heat, such as a stove or heater,
cause the appliance to perform improperly.
•
Do not use the appliance near water, for example in a wet basement or near a sink.
•
This appliance is intended for household useonly. It is not designed for outside installation,
including anywhere that is not temperaturecontrolled (garages, porches, vehicles, etc.).
•
Before connecting the appliance to a power source, let it stand upright for approximately6 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
•
This appliance is 44.9 cm (17.68 inches) wide by 67.8 cm (26.69 inches) high by 47 cm(18.5 inches)
deep. Make sure that you leavethe minimum amount of space between the appliance and all surrounding
walls and vents.
•
Allow 12.7 cm (5 inches) of space between theback of the appliance and the wall. Allow 5 cm (2 inches)
between the sides and top of the appliance and any walls or counter tops.
•
This appliance is intended for free-standing installation only and is not intended to be
built into a cabinet or counter. Building in this appliance can cause it to malfunction.
FEATURES
2
INSTALLATION INSTRUCTIONS
OPER ATING INSTRUCTIONS
Door Liner With Can Dispenser:
Holds 355ml
cans of pop,juice, or beer.
1. Freezer Compartment with Door
2. Thermostat Dial and Push Button Defrost
3. Drip Tray
4. Glass Shelves
5. Magnetic Gasket:
Tight fi tting door seal keeps
all the cooling power locked inside.
6.
7. Bottle Rack:
For tall, small and medium cans or
jars.
8. Leveling Leg:
Adjust so the unit is level.
