RCA RCUSAT1, Manual, Page: 14 / 24

14
Programming With Code Search
Getting Codes From Your Universal Remote
1. Manually turn on the device you wish to program.
2. Press and hold CODE SEARCH until the Indicator Light
lights, then release CODE SEARCH.
3. Press and release the device button for the device you are
programming (
TV, VCR, SATELLITE
or
AUX)
. The
Indicator Light will blink once, then remain lit.
Note: For AUX (when not an audio code) press AUX
followed by the device button. Use
SAT
for
CABLE.
4. Press and release POWER until your device turns off.
Important: You may have to press Power up to 200 times.
5. When your device turns off, press the ENTER button, the
Indicator Light will turn off.
1. Press and hold CODE SEARCH until the Indicator Light
lights, then release CODE SEARCH.
2. Press and release the device button for the device’s code
you are retrieving (
TV, VCR, SATELLITE
). The Indicator
Light will blink once.
Note: For AUX (when not an audio code) press AUX
followed by the device button. Use SAT for
CABLE.
3. Press and release CODE SEARCH . The Indicator Light
will turn off.
4. Starting with 0 on the keypad, press the number
buttons in order ( 0-9 ) until the Indicator Light blinks.
5. The number which causes the indicator light to blink is the
first digit of your code.
6. Repeat step 4 until you have retrieved all three
If your TV, VCR, Satellite Receiver, Cable Box or Audio System does not respond after you
have tried all the codes for your brand, or if your brand is not listed, try searching for your
code by following the steps below.
If you need to find the three-digit code for your TV, VCR, Satellite, Cable Box or Audio
Component after your device is set-up using Code Search, use this procedure.
CODE SEARCH
POWER
ENTER
TV VCR
AUX
SATELLITE
OFF
BLINK
OFF
BLINK
BLINK
CODE SEARCH
1
9
TV
VCR
AUX
SATELLITE
CODE SEARCH
…
INDICA-
TOR LIGHT
INDICA-
TOR LIGHT
Sat 1 Manual 6/10/99 11:14 AM Page 14