Playback on a TV (or VCR) Using the Antenna Connection
Installation
1 Disconnect the VHF antenna from your TV
(or VCR). Connect the antenna to the VHF IN
connector on the RF output adapter if you are
going to leave the adapter connected to the TV
(or VCR).
Note: If your VHF antenna is the flat twin-lead type
attached by two screws, you will also need an optional
300/75 ohm transformer, such as 193983 shown on
page 6.
32
2 Attach one end of the coaxial RF cable to the
VHF OUT connector on the adapter and attach
the other end to the VHF input on your TV (or
VCR) as shown.
3 Attach the RF output adapter’s plug to the
output jacks located behind the door on the side
of the camcorder as shown above.
OR
2
Back of TV
VHF Antenna
Coaxial
RF Cable
(supplied)
CHANNEL
4CH/3CH
Switch
RF Output
Adapter
(supplied)
Optional 300/75
Ohm Transformer
(such as 193983)
Output Jacks
(Located behind door)
VHF Antenna
OR
VHF
VHF
IN
FROM
ANT
REW
F.FWD.
BATTERY
STOP
MODE SEL.
AUTO LOCK
MANUAL FOCUS
ON
OFF
+
–
FOCUS
PLAY
ADJ.
DATE/TIME
RES.
MEM
COUNTER
PULL
1
3
Back of TV
or VCR
The unauthorized recording of television
programs and other recorded material
may infringe the rights of others.
To connect your camcorder to a TV using the
antenna connection, you will need the RF output
adapter and coaxial RF cable that came packed with
your camcorder. If your TV is already connected to
a VCR, you can attach the camcorder to the VCR
and watch what the camcorder is recording or
playing on the TV.
