2
Hardware Kit
(A) M8 x 63 Lag Bolt (x4)
(B) Lag Bolt Washer (x4)
(C) Concrete Anchor (x4)
(D) M4 x 12 Bolt (x4)
(E) M4 x 20 Bolt (x4)
(F) M6 x 12 Bolt (x4)
(G) M6 x 30 Bolt (x4)
(H) M8 x 12 Bolt (x4)
(I) M8 x 30 Bolt (x4)
(J) M6 Washer (x4)
(K) Spacer (x8)
(L) 3/16” Drill Bit
Mounting the wall plate
Drywall Installation
Important!
For safety reasons, this mount must be secured to at least two wood studs no less than 16” apart.
The studs must be capable of supporting the combined weight of the mount and display.
4.
Set the wall plate aside and drill a 3/16” pilot hole at
each marked location.
5.
Place the wall plate back against the wall and
attach it using the lag bolts (A) and lag bolt washers
(B) (see Fig. 2).
Do not over-tighten these bolts
and do not release the wall plate until all bolts
are in place.
Ensure that the wall plate remains
level after all bolts are secured.
1.
Use a high quality stud fi nder to locate two adjacent
studs where you wish to install your mount. Mark
both edges of each stud to help identify the exact
center.
NOTE:
You must use the center of each stud
to avoid cracking or splitting the wood during
installation.
2.
Place the wall plate against the wall and level it
using the integrated bubble level.
Fig.1
Fig.2
3.
While another
person holds
the wall plate in
position, mark four
locations (two per
stud) for securing
the mount to the
wall (see Fig.1).
