Chapter 2
27
Using the Remote Control
4.
Press and release PLAY, then wait 5 seconds or until the component button stops flashing.
At this point the remote is searching for the correct code to program. If, after 5 seconds, the
component you want to operate does not turn off, press PLAY again to tell the remote to search
the next set of codes.
Continue pressing and releasing PLAY until the component turns off or you have searched
through all of the codes. The component buttons flash when all codes have been searched,
the component button turns off, and the remote exits Automatic Code Search.
If the component you want to control
does
turn off:
1.
Press and release REVERSE, then wait 2 seconds. Repeat this step until the component turns
back ON.
2.
To finish, press and hold STOP until the component button on the remote turns off.
Using Direct Entry
1.
Turn on the component you want to operate (VCR, DVD player, etc.)
2.
Look up the brand and code number(s) for the component on the code list in this section.
3.
Press and hold the component button you want to program on the remote.
4.
Enter the 4-digit code from the remote control code list on the following pages. If the
indicator flashes, you have either entered an invalid code or the button isn’t programmable.
5.
Release the component button, point the remote at the component, and then press ON•OFF
to see if the component responds to the command. If it doesn’t, try pressing the component
button and then ON•OFF again.
•
If you get no response, repeat these steps using the next code listed for your brand, until the
component responds to the remote commands.
•
If you try all the codes for your component brand and none work, try the automatic code
search method. If automatic code search doesn’t find the code, the remote is not compatible
with your component.
How to Use the Remote After You’ve
Programmed It
Because this universal remote can control several different components (TV, DVD, VCR, satellite
receiver, etc.), it uses operational modes triggered by the component buttons.
1.
Press the appropriate component button (DVD, TV, VCR, SAT/CAB, AUDIO, AUX) to set the
remote to control the component.
2.
Press ON•OFF to turn the component ON or OFF.
3.
Use the remote buttons that apply to that component.
Notes:
The remote control may not be compatible with all brands and models of
components.
If you keep pressing buttons and nothing happens, the remote is probably in the wrong
mode. You must press the component button that matches the component you want to
operate (i.e., if you want to operate the VCR, press VCR on the remote control to put the
remote in VCR mode.)
