1
ANTENNA
1
2
3
4
Setup and Connection
Step 1: Connect Your TV
Connect the cable from your cable system or off-air antenna to the cable in-
jack on the back of the TV, as shown.
Step 2: Plug In Your TV
Plug the end of the power cord into the wall outlet, matching the wide
blade of the plug with the wide slot in the outlet. Be sure to insert the plug
completely.
Step 3: Put Batteries in the Remote Control
1. Remove the battery compartment cover from the back of the
remote.
2. Insert batteries as shown, matching the + and – ends of each battery
in the compartment.
3. Replace the cover.
Step 4: Turn on the TV
Press the POWER button on the remote or front panel.
Step 5: Auto Channel Search
Perform an
Auto Channel Search
(described in the
Channel
menu section).
Dipole Antenna Connection
Follow the steps to connect the indoor antenna supplied with your TV (only
if you do not connect an outdoor antenna or a cable-TV system).
Insert the antenna base into the pocketed slot on the back of your set.
Stand at the back of your set with the antenna twin-lead facing you, and
press the base of the antenna into the slot until it locks in place.
Connect the ends of the twin-lead to the Antenna Adapter (supplied).
Connect the Antenna Adapter to the ANTENNA
connector on the back of
the TV.
Later, after you’ve turned on the TV, adjust the length and position of the
antenna rods for best reception.
• For viewing VHF channels, extend the rods fully.
• For viewing UHF channels, shorten the rods for best reception.
TV (Back Panel)
CABLE/
ANTENNA
ANTENNA, CABLE, CABLE BOX OR VCR
GETTING STARTED
Antenna Adapter
(Supplied)
Dipole Antenna (Supplied)
Slot
Base
Twin Lead
