25
Using the Remote
3.
Press and hold the button on the remote you want to program.
4.
Enter the code from the code list.
5.
Release button, and then press ON•OFF to see if the component
responds to the remote commands. If it doesn’t, try pressing the
component button and then ON•OFF again.
6.
If you get no response, repeat these steps using the next code listed
for your brand, until the component responds to the remote
commands.
Using the Remote to Control a Device
Once the remote has been programmed successfully, you are ready to
use it to control your devices.
To operate the device:
1.
Press the device button (TV, VCR1, VCR2, AUX, or SAT•CABLE) to set
the remote to control the device.
2.
Press ON•OFF to turn the device ON or OFF.
3.
Use the remote buttons that apply to that device.
Modes of Operation
Because this universal remote can control several different components
(VCR, Cable Box, etc.) it uses operational modes triggered by the
component buttons. For example if you want the remote to control the
TV, you would press the TV button to put the remote into TV mode
before you could control the TV.
Front Panel
If you cannot locate your remote you can use the front panel of your TV
to operate many of the TV’s features.
MENU
Brings up the Main menu. When in the menu system, it selects
highlighted items. Also returns you to the previous menu.
CH v
Scans down through the current channel list. In the menu system,
it points down to items and adjusts menu controls.
CH ^
Scans up through the channel list. In the menu system, it points
up to items and adjusts menu controls.
VOL –
Decreases the volume. When in the menu system, VOL – is used
to point left to items and adjust menu controls.
VOL +
Increases the volume. When in the menu system, VOL + is used
to point right to items and adjust menu controls.
POWER
Turns the TV on and off.
The Front Panel Block feature disables all
front panel buttons. For more
information, see “Parental Controls,” in
the
Features and Menus
section.
