5
The ANT3900 installation consists of three basic steps:
Step A: Installing the ANT3900 on your satellite dish.
Step B: Installing the inside diplexers.
Step C: Setting up your TV to use the ANT3900.
Please be sure to complete all of these steps before attempting
to watch local channels with your ANT3900. If your dish
uses a multi-switch, please skip to the multi-switch section
on page 10.
Installing Your New
ANT3900 Antenna
TV
SAT
TV/SAT
INSIDE DIPLEXER
TV
SAT
TV/SAT
INSIDE DIPLEXER
Step A: Installing the ANT3900
on your satellite dish
1. Make sure all satellite receivers are turned off and
unplugged from the electrical outlet.
2. Unsnap the antenna from the back notch of the mounting
clamp (see Fig 3).
3. Hold the antenna to the back of the dish so that the circular
housing is centered with the RCA logo facing out (see Fig 2).
4. Maneuver the clamps over or around the edge of the dish
one at a time (see Fig 4).
5. Tighten the mounting clamp by turning the thumb-wheel
screw clockwise and re-snap antenna on to back notch.
Note:
We recommend the use of the enclosed security clips.
Snap the security clips onto the ANT3900 and slide down
towards the mounting clips.
Fig 1
Fig 2
Security Clip
RCA ANT3900 4/29/03 9:19 Page 5
Summary of Contents for ANT3900
Page 7: ...7 Fig 5 Fig 9 Fig 6 Fig 7 Fig 8 RCA ANT3900 4 29 03 9 19 Page 7 ...
Page 9: ...9 Fig 12 Fig 13 RCA ANT3900 4 29 03 9 19 Page 9 ...
Page 11: ...11 Fig 14 Fig 15 Fig 16 RCA ANT3900 4 29 03 9 19 Page 11 ...
Page 13: ...13 Fig 17 Fig 18 RCA ANT3900 4 29 03 9 19 Page 13 ...
