rc3Dprint QUICKIE, Assembly Instruction Manual

Page: 10 / 22

A S S E M B LY
1. D R Y F I T E A C H P I E C E T O G E T H E R B E F O R E G L U I N G I N
P L A C E . T H I S I S T O C H E C K F O R F I T .
2. T H E R U D D E R H I N G E I S G L U E D I N P L A C E W I T H T H E
F I N D U R I N G A S S E M B LY. E I T H E R F I N 2 O R T H E
R U D D E R B O T T O M N E E D S T O B E G L U E D O N L A S T
W I T H T H E H I N G E I N P L A C E .
3. T H E A I L E R O N S A N D E L E V A T O R S A R E G L U E D I N P L A C E
D U R I N G W I N G C O N S T R U C T I O N .
4. T H R O U G H O U T T H E B U I L D , A D H E S I O N S S H O U L D B E
C A R E F U L LY R E M O V E D A N D F A C E S T O B E G L U E D
T O G E T H E R S H O U L D B E S A N D E D F I R S T T O E N S U R E
G O O D C O N T A C T . T H I S I S
C R I T I C A L . T I M E T A K E N
H E R E W I L L E N S U R E S Y O U R A I R C R A F T I S S T R O N G .
-
Begin by marking out the drill holes for your motor mount. I use the small servo sized
screws in a 1mm drilled hole. A
mount plate to be printed in regular PLA or ABS is
provided. This goes inside the fuselage 1, you can glue it in place then the drill the mount
holes all at once.
-
Glue together fuselage pieces 1, 2 and 3. It is a good idea to fit the rudder servo into
fuselage 3 at this stage. A dab of hot glue on the sides of the servo works well for this.
4 M U S T R E A D P O I N T S