P R I N T I N G P R O F I L E S
* If printing in LW-PLA from Colorfabb we recommend following the calibration process
suggested by the manufacturer regarding nozzle temp and flow, below are suggestions
L W - P L A P R O F I L E
Save this profile as LW-PLA. Changes to generic ‘Low Quality’ PLA profile.
P L A A N D T P U P R O F I L E
You can use your standard settings for the parts printed in TPU and PLA, as they are not
structural.
Layer height
0.24mm
Wall Thickness
0.4mm
Wall line count
1
Top/Bottom Pattern
Lines
Infill Density
3%
Infill Pattern
Cubic
Flow
50%*
Printing Temperature
240C*
Build Plate Temperature
60C (optional)
Fan Speed
20% Maximum
Generate Support
No
Build Plate Adhesion
Brim or Skirt
Summary of Contents for MICRO PEREGRINE FLYING WING
