Frame Assembly Continued
This step will add the lower frames, the tail gears & bearing block.
There looks to be a lot to do in this section but both sides are
identical.
It will probably be easier to follow the smaller images below as
they show fewer items and the best order in which to put them
together.
Note: When adding the lower frames, screws and spacers for
images 4 & 5 it is best to put them all in finger tight resting the
model on something flat to make sure the frames are parallel
and then removing one screw at a time add threadlock and
screw in tight.
Frame B x 2
Tail Gear x 1
Bearing Block x 1 Bearing Block x 1 Gear x 1
Screw 7mm x 6
Screw 15mm x 8
Screw Cap x 14
Spacer x 8
Small Shaft x 1
Standoff x 1
Copyright © 2007 RC-TEK, All Rights Reserved
Parts Required
1
2
3
4
5
6
Threadlock all screws per
notes on the left