32
Check Clutch
1.
Place unit in service position. See
Service
Position
on page 20.
2.
Measure gap between the armature and
rotor:
•
A 0.4 mm – 0.5 mm (0.016" – 0.020")
feeler gauge should fit between the
armature and rotor and make slight
contact with each.
3.
Repeat measurements for remaining
inspection slots.
4.
If gap is within range, no adjustment is
needed.
Figure 42
Adjust Clutch
1.
Place unit in service position. See
Service
Position
on page 20.
2.
Loosen adjustment nut until a 0.5 mm (0.020
in.) feeler gauge fits between armature and
rotor.
3.
Tighten adjustment nut until armature and
rotor make slight contact with feeler gauge.
4.
Repeat at remaining inspection slots.
NOTICE: Air gaps MUST be even at all inspection
slots.
REVERSE CLUTCH BRAKE PLATES
See Figure 43.
5.
Remove hardware securing brake plates to
clutch bracket. Retain for reinstallation.
6.
Reverse the brake plates and secure to
clutch bracket using original hardware.
Figure 43
