30
| Transmitter
3.
Press and hold the bind button located next to the battery connector of the »Xtreme for
2 to 3 seconds. Wait until the status LED starts flashing red and green. The »Xtreme
is now in bind mode.
4.
Press and hold the middle button on the “OneLINK”
. An audible signal will be emitted.
The status LED on the »Xtreme will start flashing (green, orange, or red) depending on
what flight mode is enabled on the transmitter.
16.3.7 Verify learning
IMPORTANT! Test 1 must be completed before flying!
Ensure the »Xtreme stands on a level surface!
Test 1 - Gyro reset
>
Move
AILERON
right and
ELEVATOR
up (top right corner).
>
GYRO should initialize (the status LED of the »Xtreme turns green).
Test 2 - Orientation LEDs
>
Move
AILERON
right and
ELEVATOR
down (bottom right corner).
>
The
ORIENTATION
LEDs turn on or off depending on their state. Repeat the steps
to switch states.
Test 3 - Flight modes
>
Toggle the first assigned 3 position switch (AUX-1) (
throttle must be at zero
).
>
Positions:
»
Position 1 = Green blinking (Beginner mode)
»
Position 2 = Orange blinking (Sport mode)
»
Position 3 = Red blinking (Expert mode)
Test 4 - Acrobatic/Normal/Height hold
Test 4 must be performed in SPORT mode!
To turn off altitude height hold mode toggle the second
assigned switch (AUX-2) back to position 2 (centre) and
move the throttle stick up or down.
>
Toggle second assigned 3 position switch (AUX-2):
»
Position 1 = Fast blinking status LED (acrobatic mode activated)
»
Position 2 = Normal blinking (normal flight mode)
»
Position 3 = Fast blinking (altitude height hold mode)
16.3.8 DX6I with only 2 position switch
16.3.8.1 Workaround introduced
When using the Spektrum DX6i you cannot toggle between the 3 flight modes (Beginner,
Sport, and Expert). Besides, it disables one of the two features in Sport mode as toggling
between the 3 features requires a 3-position-switch.
>
Both
ALTITUDE HEIGHT HOLD
function and
ACROBATIC MODE
are only engaged
when flying in Sport mode, and are automatically omitted when flying in Beginner, or
Expert mode.
>
Users can, however, toggle between
NORMAL FLIGHT
and one special feature using
the DX6i.
Please read the following sections to acquire more information about the possible
workarounds.
Summary of Contents for 88007RC (Mode 1)
