Using the Finch Serial module
Powering the module
To power the module, connect it to a tablet or phone via Finch USB cable. Connect Jeti Cable to Finch 3-
pin JR connector or JR cable from Core to JR conenctor. Connect onboard unit and green LED must turn
on. Run the Albatross application and you are ready to use it.
Update via SD card
To make an update make following:
1. Download latest firmware for Finch from our web site. Firmware should have name Finch.rcu
2. Copy Finch.rcu to root of SD card
3. Insert SD card to Finch module and power it up.
4. Wait for 5-8s until all LED lights will toggle shown
5. Remove SD card and check “Finch info.txt” file that new version is installed.
Finch info.txt example:
Device: Finch
- device name
Serial No: 190001
- device serial no.
HW: 1.1
- HW version of device
Produced: 20.12.2019
- date of production
FW v: r.0.9.B110
- FW version installed
F
inch Serial
- Converting different serial protocols to Albatross protocol
Page 5
