RBH Sound WM-24, Owner'S Manual

Page: 7 / 12

Mounting Bracket
Using the enclosed template, mark your
desired speaker location.
NOTE: the bracket is offset to allow for the
slide mount of the speaker onto the bracket.
The offset allows the speaker to be centered
when mounting is complete. If mounting in a
stud-less drywall location, use the enclosed
self-tapping drywall augers and screws.
Start the auger in the drywall location with
a few slight taps from a hammer, then screw
down snugly with a screwdriver. To mount
the bracket, hold the bracket in the desired
location and fasten with the included
screws. If you’re mounting the bracket to
surfaces other than drywall or hardwood,
we recommend you consult with a hardware
or construction professional to obtain the
best hardware for your application. RBH
recommends the use of the bubble-type
level to ensure correct positioning of your
speakers.
Four arrows in the picture point to four
screw holes which should be used to attach
the bracket to your mounting surface. The
elongated center hole in the bracket is
designed to allow the speaker wire to pass
through. The keyways indicated by the other two arrows show the locations where
the speaker mounting knobs will be inserted into the bracket.
TIP:
Prior to actually mounting your speaker, you may want to assemble the mounting
knobs and bracket to the speaker to gain a better understanding of how the pieces work
together.
NOTE:
When mounting in a vertical position, the speaker should always slide down
onto the bracket.
5