UNC500 Hardware Manual V1.3
RBH Access Technologies Inc.
Page
14
of
32
Telnet
To program the UNC500 through Telnet you first have to set all DIP switches off.
Connect to the panel with an Ethernet cable and configure your computer to have IP
address 192.168.168.20 [
remember to reconfigure your machine’s IP address back
when you are done
]. In the ‘cmd’ window type the following ‘telnet 192.168.168.125’.
If a connection is made the following message will be displayed.
Telnet Opened on port 23
2 MEG RAM detected.
A password is required in order to change user parameters. The default password is
‘
password
’. The password can be changed by the user. After entering the password the
following items are available for the use to alter.
Name
Defaults
Description and notes
IP ADDRESS
192.168.168.125
Local Ethernet address.
SUBNET MASK
255.255.255.0
Local Ethernet mask
IP GATEWAY
0.0.0.0
For future use when DNS option becomes available.
PORT NUMBER
3002
Primary port number.
ALT PORT NUMBER
3003
Alternate port number applies to “LAN” application.
CH1 APPLICATION
HOST
Com channel #1 application located on the side opposite the power input.
CH2 APPLICATION
DNET
Com channel #2 application located below #1.
CH3 APPLICATION
UNC-NET
1
NCNET
NONE
Com channel #3 application located on the same side as the power input. To use
this channel the three jumpers must be in the “r” position. (
If you are connecting
to NC-100s set the value to “C-NET”, and the jumpers must be set to the “A”
position
.)
Telnet Password
password
This is a string of up to 10 characters that allows the user access to this program.
1
Channel 3 default selection depends on the version of firmware in the UNC500.
