CA-200
Discrete Class A/B Subwoofer Amplifier
200 Watts RMS @ 4 Ohms
<.04% @ 1 Watt
>82dB (without filter)
45 Kohms
200 Ohms
80 mV
2.8V
12dB/Octave
40-180Hz ±dB
2 mV @ 50 Hz
20Hz-40kHz ±3dB (filter off)
4dB @ 25Hz
>200
Black Metal Alloy
10” W x 10” H x 5.75” D
(482mm W x 101mm H x 355mm D)
14 lbs. (6.35 kg)
1 year
Model:
Amplifier Type:
Power Output:
Distortion (THD):
S/N Ratio:
Line Level Input Impedance:
Speaker Level Input Impedance:
Line Level Input Sensitivity:
Speaker Level Input Sensitivity:
Crossover Slope:
Crossover Freq. Range:
Auto Turn-on Sensitivity:
Frequency Response:
Boost:
Damping Factor:
Cabinet Material and Finish:
Dimensions:
Weight:
Warranty:
No sound from
subwoofer.
Performance
is less than
expected.
Amplifier is not connected to constant
power outlet.
Amplifier is not receiving an audio
signal from receiver or processor.
Amplifier fuse might be blown.
The + and - polarity of the subwoofer
wire might be reversed on the
subwoofer.
Crossover frequency not adjusted
correctly.
L/R line level input is connected
instead of the LFE line level input.
Troubleshooting
Probable Cause:
Situation:
Make certain the amplifier is
plugged into an unswitched AC
power outlet.
Make certain there is an audio sig-
nal from receiver or processor.
Replace fuse (if fuse is not readily
accessible, consult your authorized
RBH Sound dealer).
Check the entire system for proper
polarity. Experiment with the phase
switch settings.
Adjust the crossover frequency by
turning the crossover frequency
control clockwise until the desired
sound is obtained.
If bass management is enabled on
receiver or processor make sure to
use the LFE line level input. (See the
Amplifier Controls and Setup section of
Solution:
Specifications
4
