3
ASSEMBLY AND SET-UP
Assembling the T-bar
Tool required: 8 mm wrench and Philips Screwdriver.
WARNING:
Failure to
properly install and tighten the
handlebars and the plastic cover
may cause the rider to lose control
and fall. If you do not understand
these instructions, contact Razor
customer care for assistance.
NOTE:
Make sure the Razor logo
is facing outward when inserting
the T-bar.
3
Tighten the bolts. Note: End of bolts should extend beyond nut 1-2 mm after tightening.
1
Using the 8 mm wrench and Philips Screwdriver
remove screws (x2) from the front fork.
2
Slide the T-bar on to the front fork.
