Razor Dirt Rocket MX500 Replacement Procedures Download Page 3

Page: 3 / 4

Need Help?

Visit our website at

www.razor.com

or call toll-free at

866-467-2967

Monday - Friday 8:00am - 5:00pm Pacific Time.

Step 9

Step 10

Step 7

Step 8

Using a 3 mm Allen wrench, loosen the throttle screw but

do not remove and move throttle away from the grip.

Follow the throttle wire and disconnect it from control

module. Cut the zip tie and remove the cable wrap.

Note: save the cable wrap for reassembly. Gently pull the

throttle cable through the hole in the number plate.

Using a 5 mm Allen wrench, loosen the srcew on the

brake lever and move it away from the throttle.

Insert a flathead screwdriver in between the handlebar

and grip and apply WD-40

or a few drops of water.

This will allow you to remove the grip and throttle from

the handlebar.

Summary of Contents for Dirt Rocket MX500

Page 1: ...charger before conducting any assembly or maintenance procedures Failure to follow these steps in the correct order may cause irreparable damage Using a 5 mm Allen wrench and a 10 mm wrench remove the...

Page 2: ...screws 1 on each side holding the control module in place and remove the control module Carefully cut the zip ties holding the wires together Disconnect the six 6 white plastic connectors attached to...

Page 3: ...rottle wire and disconnect it from control module Cut the zip tie and remove the cable wrap Note save the cable wrap for reassembly Gently pull the throttle cable through the hole in the number plate...

Page 4: ...the throttle in place and secure it back in place clean the grip from any water or lubricant an re install Reconnect the throttle to control module Place the battery cover back on the unit Refasten th...