background image

8

Need Help?

 Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information 

at 

www.razor.com

. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service 

contact information is listed at the back of this manual.

*Product(s) should be turned off and fully charged prior to doing any Troubleshooting

NOTE:

 All troubleshooting steps should be performed by an adult only

 TROUBLESHOOTING  GUIDE

Problem

Possible Cause

Solution

Product does not run.

Undercharged battery.

Charger is not working.

Charge the battery. A new battery should have been charged for at least 

12 hours before using the product for the first time and up to 12 hours after 

each subsequent use.

Check all connectors. Make sure the charger connector is tightly plugged 

into the charging port and that the charger is plugged into a functioning 

wall outlet.

Contact Razor Customer Service to get replacement charger.

Product was running but 

suddenly stopped.

Loose wires or connectors.

Check all wires and connectors to make sure they are tight.

Short run time.

Undercharged battery.

Battery is old and will not accept  

full charge.

Charge the battery. A new battery should have been charged for at least 

12 hours before using the product for the first time and up to 12 hours after 

each subsequent use.

 

Refer to page 4. Replace only with a Razor replacement battery.

Product runs sluggishly.

Riding conditions are too stressful.

Product is overloaded.

Use only on solid, flat, clean and dry surfaces such as pavement or  

level ground.

Make sure you do not overload the product by allowing more than one 

rider at one time, exceeding the maximum weight limit, going up too steep 

a hill or towing objects behind the product. 

Sometimes the product doesn’t 

run, but other times it does.

Loose wires or connectors.

Motor or electrical switch damage.

Check all wires connectors to make sure they are tight.

Contact your local Razor authorized service center for diagnosis and repair. 

Contact Razor customer service or visit www.razor.com.

Charger gets warm during use.

Normal response to charger use.

No action required. This is normal for some chargers and is no cause for 

concern. If your charger does not get warm during use, it does not mean 

that it is not working properly.

For more troubleshooting tips, a list of available replacement parts or to locate an authorized Service Center in your area,  

visit our website at www.razor.com or call toll free +1 866 467 2967 to speak to a live Customer Service Representative

Summary of Contents for crazy cart shift













Reviews: