RQD032ENr02 Rev. Date: 2021-12-24
11
2.5 Adjustable Footrest Installation
1. Place the footrest hanger tubes into the receivers at the front
of the frame.
If the foot supports are oriented forward, the pins on the foot
support hangers will engage with the grooves in the receivers
and lock in place.
2.6 Wheel Installation
– Z
üm
-SP
1. Remove the hub cap on the wheel and discard.
Hub caps are not compatible with quick-release axles.
2. Insert the quick-release axle through the wheel and axle
receiver.
3. Ensure the ball ends of the quick-release axle are fully
released and prevent the quick-release axle from
inadvertently sliding out.
To test that the quick-release axle is locked in place, release the
button and attempt to pull the wheel away from the chair. The wheel
should remain in place. If the wheel cannot be secured in place, do
not use the Züm-SP and contact your detailer immediately.
4. Repeat steps 1-3 for the other side.
2.7 Fastener Installation
All fasteners should be installed securely. Locknuts that are
removed for any reason may need to be replaced rather than
re-used. Check performance of locknuts when re-attaching to
screw. There should be significant, detectable resistance when
tightening. If not, replace the locknut with a new one. It is
advisable to check quarterly that all fasteners are secure.
