RQD014ENr05 Rev. Date: 2022-10-25
10
2.0 SET-UP: INTENDED FOR DEALER USE ONLY
2.1 Backrest Installation
Tools required: 6mm hex key, 13mm wrench
1. Remove the shower chair from the shipping carton.
2. Lift the backrest to an upright position.
3. Insert the button head cap screw
through
one
of the two holes in
the middle of the outer backrest plate.
NOTE: Select the rear hole for a 95° backrest or front hole for 100°
backrest angle.
TIP: A Phillips screwdriver can be inserted through one plate and
frame to temporarily secure the backrest in an upright position.
4. Fasten the other end of the screw with a nyloc nut.
5. Tighten the assembly with the hex key and wrench until the end
of the screw extends 1 or 2 threads beyond the nylon locknut.
6. Repeat steps 3 to 5 for other frame tube.
TOP VIEW OF BACKREST ASSEMBLY
2.2 Raz Seat Installation
1. Ensure that the front spring brackets are in the open position.
To open the front brackets, squeeze to unlatch.
2. Slide the rear of the seat over the rear cross tubes as the
front of the seat is lowered onto the frame. Check to make
sure that the rear seat brackets hook below the cross tubes.
3. Continue lowering the front of the seat until the front seat
brackets nestle onto the front seat support tubes.
4. Secure the seat in place by closing the front seat brackets.
To close the seat bracket, squeeze the clip and close
the bracket around the front support tubes.
5. Reverse steps 1 to 4 to remove the seat from the frame.
