Raytheon Anschütz 108-010.NG001 E01, Operator'S And Service Manual

Page: 41 / 80

Magnetic Sonde
7 Installation and Maintenance
Edition:003 31 4423
Procedure
Fig. 12: Replace Holder for 108-010.NG001, 108-010.NG002 and 108-010.NG004
1 Plate
2 Ground Plate
3 Screw
4 Washer
5 Magnetic Sonde
6 Nut
7 Washer
8 Spacer
9 Thread Bar
1. Measure and note the distance between the plate ( Fig. 12 /1) and the ground plate
( Fig. 12 /2).
2. Remove the 3 screws ( Fig. 12 /3) with washers ( Fig. 12 /4).
3. Remove the magnetic sonde ( Fig. 12 /5).
4. Provide a new holder.
5. Dispose of the defective holder.
6. Check the distance between the plate (
Fig. 12 /1) and the ground plate of the new
holder.
7. If necessary, correct the length with the installation kit.
a) Remove the 3 nuts ( Fig. 12 /6) with washers ( Fig. 12 /7).
b) Remove the plate ( Fig. 12 /1).
c) Correct the length with the spacers ( Fig. 12 /8) and the thread bars ( Fig. 12 /9) from
the installation kit.