3.
Hardware Installation
1. Mount the Access Point firmly to the wall or proper location that is determined during the site survey.
2. Make sure the antennas are in a vertical position (if not, rotate over 90 degrees).
3. Insert the power connector.
4. Attach the UTP Ethernet cable to the Access Point.
At the front of the Access Point you will see three LEDs.
If all goes well, the middle LED (power) and the lowermost LED(LINK) will fire and uppermost
LED(ACT) will flash whenever there is traffic on the respective networks which is at least ten times per
second for the wireless LAN because of so-called ‘beacons’.
You can reset the Access Point’s settings to factory defaults by pushing a paperclip in the little hole
next to the power connector.
User’s Guide
5
