6.3. How to Start Scanning
This section describes how to start scanning using a physical button (hardware) or the AT
Command (firmware) under various occasions. Before getting started, here are some notes
applied to both methods.
⚫
Each central device is only able to pair with 1 Peripheral.
⚫
The device will be in idle directly when it is powered or not in BLE connection. It will go
into deep sleep after a given timeout (no timeout in default).
⚫
A few criteria must be met in order to complete BLE connection:
Under
Paired Scanning
Under
All-Devices Scanning
Base UUID
√
√
Service UUID
√
√
Device name
√
√
RSSI Threshold
√
Mac Address
in Paired Record
√
Summary of Contents for MDBT42Q-AT-UART-M
Page 6: ...3 Reference Circuit...
