4. Pair / unpair the wall panel to receiver
The wall panel needs to be paired to receiver to work. User can pair up to 5 wall
panels to one receiver and each wall panel can be paired to any receiver.
To pair or unpair wall panel to the receiver, please operate with following steps:
1). Cut off the power of receiver and power on again after more than 5 seconds.
2). Touch and key simultaneously and briefly within 10 seconds after receiver
powered on.
3). Release all keys, then touch key or 1-4 digit key within 10 seconds to pair the
panel to receiver. For key, the receiver will be paired without group feature, for 1-4
key the receiver will be paired to 1-4 target group.
4). To unpair the panel from receiver, do the step 1-2 first, then release all keys and
press key within 10 seconds.
Operation
Turn on/off lights.
Touch to activate color
changing. Double
click to change color
mixing mode.
Touch to activate group
function for digit keys.
The beeper will sound
twice when in group
mode.
At scene mode
: click
to recall the scene,
hold press to save
current status to the
scene position.
At group mode
:
select destination
group, only current
group member will
response to the
panel after
selection.
Function
Switch group mode to
all members. All
paired receivers will
response to the panel
after touching this key.
Dimming / Changing color. Slide
upward or downward to increase or
decrease brightness / color. Touch the
top or bottom section to jump to
maximum or minimum value.
6. Slider and shortcut key
The default function for the slider is dimming, user can slide up or down or adjust
brightness step by step or slide and hold to adjust continuously
.
When key is
touched, the slider function will swap to color adjust shortly and the operation method
is same as brightness adjusting.
The top and bottom section of the slider is shortcut key to max or min value. For
brightness adjusting, touch the slider top section will jump to maximum brightness and
touch the bottom section will jump to the minimum.
Specification
AC version working voltage
Battery version working voltage
Wireless protocol
Frequency band
Wireless power
Working temperature
Panel dimension
AC90-265V
DC3V, CR2032 battery
Umi protocol based on SIG BLE Mesh
2.4GHz ISM band
<
7dBm
-20-55 C(-4-131 F)
86x86x10mm (Europe standard)
t
a
p
y
s
a
E
f
f
o
/
n
o
7. Easy pat on/off
For the most frequently used turn on and off function, besides touching the on/off
key, user can also pat on the panel with whole palm, this gesture will also turn on/off
the lights. The pat operation is more convenient for daily use.
5. Change RGB/White mixing mode
Double click the key to change color mixing mode.
For RGB+White and RGB+CCT application, the color mixing mode can be switched
between white(CCT), RGB and White(CCT)+RGB mode.
9. Switch target group
To switch the target group, please press the key first, then press the target
group digit key. For example, to switch to group one, please press then key. The
wall panel function will switch to the target group shortly. To restore the remote
controller to all groups, please press key.
8. Load and save scenes
The default function of 1-4 digit keys are for scene function. User can short press 1-4
key to load scene. To save a scene, please adjust the favorite light status first, then hold
press 1-4 digit key to save current status to relative scene position. After save operation,
user can load the saved scene by short press the digit key.
10. Turn ON/OFF beep sound
A beeper is equipped in the panel and the beep sound is ON as default. To turn on/off
the beeper sound, please hold press the key for about 1 second, the beeper on/off
status will swap.