Wall panel touch remote controller
BW03-C(A/B)
Battery:
CR2032
General Purpose
Battery / AC power
Group / Scene
Open the wall panel
with a screw driver.
Battery version
:
Pull out battery
insulation tape.
AC version
: Connect AC power
and install bottom part to
socket with screw, then clip
panel part to bottom part.
Battery version
: Install the
back cover to wall with
screw or adhesive, then clip
panel part to the back cover.
Battery version
Quick installation guide
Remove
before use
This touch wall panel is designed to control compatible Single color, CCT, RGB,
RGB+White or RGB+CCT LED controllers, drivers or lighting fixtures via Umi wireless
protocol. There are two power supply options with AC power or cell battery. The AC version
can fit traditional wall installation with AC power and the battery version can be easily
installed at any preferred place.
Introduction
1
2
3
4
1. Open the touch panel
The wall panel needs to be opened before installation. Please use a slot type screw
driver to twist in the bottom side slot and open the panel. Please refer to picture 1.
AC version installation
2. Connect the AC power
Push the top of connector on the bottom part back and insert the L and N AC power
2
cables. The maximum cable gauge is 1.5mm or AWG16.
CAUTION! Cut off the AC power before installation to avoid electric shock!
1. Open the touch panel
The wall panel needs to be opened before installation. Please use a slot type screw
driver to twist in the bottom side slot and open the panel. Please refer to picture 1.
2. Prepare the battery
For new wall panel, please pull out the insulation tape under the battery. To change
the battery please slide the battery out from the battery socket and insert a new one. The
battery type is CR2032. Please refer to picture 2.
3. Install the panel
Install the back cover to preferred place by screw or double side adhesive tape, then
clip the front panel part to the back cover and finish the installation. Please refer to
picture 4.
3. Install the panel
Install the bottom part to wall socket with screws. After the bottom part is installed,
clip the front panel part to the bottom part to finish the installation. Please refer to
picture 3.
Battery version installation
AC
version
Umi Smart Wireless
