2
TT40 LED controller is designed to drive constant
voltage RGB+White color LED products in voltage range of
DC12-24V. It can be controlled by smart phone with Tuya
smart app connection or by the stand alone RF remote
controller. User can setup LED brightness, color, scene
and dynamic effects with the rich function on smart phone
Tuya app or the easy operation remote controller.
1. Power supply input
Connect positive power to the cable marked with ‘+’
and negative to the cable marked with ‘-’. The controller
can accept DC power from 12V to 24V, the output is PWM
driving signal with same voltage level as the power supply,
so please make sure the LED rated voltage is same as the
power supply.
2. LED output
Connect to constant voltage type LED load. Connect
the LED
to black cable, and R, G, B, W cable to the
relevant color . Please make sure the LED rated
voltage is same as the power supply and the maximum
load current is below the controller rated current.
CAUTION! The controller will be permanently
damaged if output cables short circuited. Please ensure
the cables are well insulated to each other.
Introduction
Functions
To 110/230
AC power
12-24V DC output
Power supply
TT40 LED
Controller
12-24V DC
LED Strips
LED Controller
12-24V Driving
4. Wiring diagram
3. Work status indicator (optional)
This indicator shows all working status of the
controller. It displays different events as following:
Steady on
: Remote and Tuya smart mode.
Flash twice
: Tuya not connected.
Flash 3 times
: Over heat protection.
Blink
: New command received.
Long single blink
: Brightness or speed reach limit.
Model: TT40 (W/Z/B)
Terminal & Size
20.5mm
60mm
1
2
3
8
12
11
5
6
9
7
EFFECT
EFFECT
Pair new
remote
Reset to
factory
Press in 10
seconds once
receiver powered
10
5. Turn ON / OFF
Press ‘I’ key to turn on unit or press ‘O’ key to turn off.
The power on status can be set to last status or default
status from app. At last status mode, the controller will
memorize the on/off status and will restore to the
previous status on next power on.
6. Light mode switch
Press this key to switch between RGB, white and
RGB+White mode. In RGB mode, white channel will be
disabled; In white mode, RGB channel will be disabled; In
RGB+White mode, all channels are usable.
Smart & Remote Control
R
G
B
+W LED Controller
High Power
Compact Size
12V/24V voltage
Overheat Protection
Wireless Remote
Tuya Smart
Wireless Remote
Tuya Smart
