Tunable White LED Controller
Wireless Remote Control
Model: P20(-S)
Full Protection
High Power
Wireless Remote
Waterproof
Compact Size
Wide Voltage Range
P20 tunable white LED controller is designed to drive
constant voltage LED products in voltage range of DC5-
24V. The main unit works with a RF remote controller, user
can setup LED brightness and color temperature from the
remote controller. The main unit is powered by DC power
supply and receives remote controller commands to drive
LED fixtures.
Introduction
1. Power supply input
Wiring & Indicator
The controller supply voltage range is from DC 5V to
24V. The red power cable should be connected to power
positive and black to negative. (For other cable color,
please refer to the labels). The LED output voltage is at
same level as the power voltage, please make sure the
power supply voltage is correct and the power rating is
capable for the load.
2. LED output
Connect constant voltage LED loads. Please make
sure the LED rated voltage is same as the power supply
and each channel’s maximum load current is in range of
the controller rated current. The black cable should be
connected to LED positive, the white cable should be
connected to cool white LED’s negative and the yellow
cable connected to warm white LED’s negative.
3. Work status indicator
This indicator shows all working status of the
controller. It displays different events as following:
Steady blue
: Normal working.
Short white blink
: Command received.
Long single white blink:
Mode cycle edge.
Single yellow flash
: Edge of the content.
Red flash
: Overload protection.
Yellow flash
: Overheat protection.
White blink
for 3 times
: New remote paired.
Please connect the controller output to LED loads
and power supply to the controller power input. The
power supply voltage must be same as the LED load's
rated voltage. Check all cables to be well connected
and insulated before power on.
To 110/230
AC power
5-24V DC output
Power supply
P20 LED
Controller
Constant voltage
LED load
Remote
Controller
5-24V DC
5-24V Driving
4. Wiring diagram
5. Turn ON / OFF
Press ‘I’ key to turn on unit or press ‘O’ key to turn off.
Main unit will memorize the on/off status and will restore
to the previous status on next power on.
Please use remote controller to turn on the unit if it
was switched to off status before power cut.
Functions
8
10
9
5
6
7
WARM
NEUTRAL
COLD
Pair new
remote
Press within 10
seconds after
receiver powered on
