8. Color temprature shortcut keys
Set the color temperature to full cool white, full
warm white or neutral white which is 50% warm and
50% cool white.
9. Remote indicator
This indicator blinks when remote controller is
working. If the indicator flash slowly when pressing keys,
it means the remote battery is nearly empty and please
change the battery in this case. The battery model is
CR2032.
10. Using the remote controller
Please pull out the battery insulate tape before
using. The RF wireless remote signal can pass through
some nonmetal barrier. For proper receiving remote
signal, please do not install the controller in closed
metal parts.
11. Pair a new remote controller
The remote controller and main unit is 1 to 1 paired as
factory default. It’s possible to pair maximum 5 remote
controllers to one main unit and each remote controller
could be paired to any main unit.
12. Keep current remote only
In some cases, one main unit might be paired with
several remote controllers but extra remote controllers are
no longer needed. User could simply pair the current
using remote to main unit again, then the main unit will
dis-pair all other remote controllers and recognize current
one only.
13. Protection
The main unit has full protection function for wrong
wiring, output short circuit, overload and overheat. The
controller will protect itself from damage at these extreme
conditions and could automatically recover when working
condition is good.
To avoid the protection, please ensure the LED fixtures
are capable for constant voltage driving and in rated range,
the cables are well connected and insulated. Also please
install the controller with good ventilation and heat
dissipation condition.
Model
N20
Brightness grade
11 levels
Brightness shortcut
3 levels
Color temperature grade
7 levels
Color temperature shortcut
3 levels
PWM grade
4000 steps
Overload protection
Yes
Overheat protection
Yes
Working voltage
DC 5-24V
Remote frequency
433.92MHz
Remote control distance
>
15m at open area
Rated output current
2x5A
Controller dimension
87x24x15mm
7. Brightness shortcut keys
Jump to the relative brightness level when press the
corresponding keys.
User could pair a new remote controller to main unit
by following two steps:
1). Plug off the power of main unit and plug in again
after more than 5 seconds.
2). Press and key simultaneously for about 3
seconds, within time of 10 seconds after the main unit
powered on.
Operation
14
15
16
Specification