Raymarine T210, User Manual, Page: 25 / 36

Setup and Calibration
23 www.tacktick.com
Master
Sets the capability for the Display to aquire network mastership.
When set to ON the current display will seize network
mastership if mastership is available.
When OFF, the current display may be assigned mastership by
the unit that is giving up mastership. The default is OFF .
Tacktick recommend you leave this setting at OFF unless advised by
www.tacktick.com.
Demonstration Mode
Allows the display to show information when NOT installed as
part of a Micronet system for demonstration purposes only.
Displays will return to
default OFF on power down.
Factory Reset
Returns all the calibration setting to the factory default values.
Health Chapter
Software Version/Network Nodes
Displays the software version, battery level and charge rate to
assist in troubleshooting and fault finding.
If the display is the "Master" (the one used to switch on the
system) then the number of items (nodes) in the system will be
shown. If the display is a "Slave" (was switched on by the
system) then the signal strength to the "Master" will be shown in place of
the number of nodes.
Hull Transmitter Signal Strength
Shows the software version (large digits), signal strength and
battery condition (level and charge rate) of the Hull Transmitter
to assist in trouble shooting and fault finding
Similar information pages are available for other transmitters if they
areconnected to the micronet network, for example:
Wind Transmitter (identified as WIND)
Wireless (NMEA) Interface (NMEA)
Mast Rotation Transmitter (MASTo)
Man Overboard Transmitter (MOB)