Chapter 3: Installation
19
2. Apply the surface mount template (supplied at the rear of this hand-
book) to the selected location and mark the centres for the fixing studs
(1) and the aperture (3) that will take the rear casing of the instrument.
3. Drill out the two 5 mm fixing stud clearance holes (2).
4. Cut out the clearance hole (3) then remove the template.
5. Peel off the protective sheet from the self-adhesive gasket (4) then
stick the gasket into position on the rear of the instrument.
6. Screw the two fixing studs into the threaded sockets on the rear of the
instrument.
7. Mount the assembled instrument, studs, bezel and gasket into the
panel. Secure from behind with the thumb nuts (5).
Flush mounting
The Flush Mounting Kit uses a low-profile bezel to reduce the fitted
profile of the instrument, to approximately 6 mm above the panel fascia.
Fitting the low-profile bezel
In order to flush-mount your ST60 instrument, you must first replace the
standard bezel with the low-profile bezel as follows:
1. Hold the instrument in both hands with the display towards you.
2. Using both thumbs, gently press an upper corner of the instrument
from the bezel, then remove the bezel from the instrument. Retain the
rubber keypad which is released when the bezel is removed.
3. Referring to the
Fitting the low-profile bezel
illustration, place the
instrument face upwards on a flat surface and place the rubber keypad
(7) in position around the display window (i.e. so that each key out-
line is located over its associated key on the instrument).
D4537-2
PDF test 81037_4.book Page 19 Friday, July 26, 2002 11:08 AM
