20
SmartPilot X-5 Wheel Installation & Setup Guide
To disconnect the Wheel Drive cable connector, pull back the cover, turn the locking
ring 90° anti-clockwise and pullout the connector. Place the attached cover on the
Wheel Drive connector to protect it.
Wheel Drive cable routing
Route the free end of the Wheel Drive cable to the Course Computer, securing the
cable as necessary at regular intervals along the route
If the wheel pedestal has a cable duct, route the cable through this. In any case,
ensure that you route the cable so it cannot foul the steering mechanism.
D10617-1
Cable
Plug cover
(pulled back)
Locking ring
Contact
Socket
Socket cover
Motor tube
Plug
D10616-1
87074_2.book Page 20 Wednesday, November 21, 2007 3:55 PM
