12
SmartPilot X-5 Wheel Installation & Setup Guide
To install the wheel drive you need to:
1. Drill the spoke clamp holes in the front cover.
2. Securing the wheel drive to the wheel.
3. Attaching the pedestal bracket.
Step 1 –Drill the spoke clamp holes
1. Remove the wheel drive front cover:
•
The front cover is held onto the wheel drive by three ‘push-fit’ posts which sit in
three sockets on the drive ring.
•
To remove the cover, hold the motor in one hand and use your other hand to
pull the cover up and away from the drive unit (as shown below).
2. Identify the appropriate spoke clamp holes for your wheel. With the arrow at the
top, refer to the following diagrams:
•
The holes are numbered inside the cover (e.g. if you have a 5 spoke wheel,
you need to drill the locations marked with ‘
5
’)
•
Mark the appropriate spoke clamp holes and check them by holding the cover
against your whee.l
D10631-1
D10632-1
5 spokes
7 spokes
Top 2 spoke clamp holes
are pre-drilled
87074_2.book Page 12 Wednesday, November 21, 2007 3:55 PM
